国产毛片a精品毛-国产毛片黄片-国产毛片久久国产-国产毛片久久精品-青娱乐极品在线-青娱乐精品

電子工程網

標題: 飛思卡爾16位單片機 [打印本頁]

作者: herohxb 時間: 2015-10-28 10:22
標題: 飛思卡爾16位單片機
MCU clock speed: 4000000 Hz
Block Module Name    Address Range Status
0  PFLASH          4000 -  7FFF Programmed - Unselected
1  PFLASH          C000 -  FFFF Programmed - Unselected
2  PFLASH       E08000 -E7BFFF Programmed - Unselected
3  PFLASH       F88000 -FFBFFF Programmed - Unselected
4  DFLASH          800 -1F0BFF Programmed - Unselected

FP: The UNPROTECT command is not available for the PFLASH flash module => Skipped.

FP: The UNPROTECT command is not available for the PFLASH flash module => Skipped.

FP: The UNPROTECT command is not available for the PFLASH flash module => Skipped.

FP: The UNPROTECT command is not available for the PFLASH flash module => Skipped.

FP: The UNPROTECT command is not available for the DFLASH flash module => Skipped.
executing .\cmd\TBDML_vppon.cmd

!// Before programming the flash, the commands written below will be executed
done .\cmd\TBDML_vppon.cmd

Vppon command file correctly executed.

FP: Operation failed on PFLASH flash module.

FP: Operation failed on PFLASH flash module.

FP: Operation failed on PFLASH flash module.

FP: Operation failed on PFLASH flash module.

FP: Operation failed on DFLASH flash module.
executing .\cmd\TBDML_vppoff.cmd

!// After programming the flash, the commands written below will be executed
done .\cmd\TBDML_vppoff.cmd

Vppoff command file correctly executed.
FP: Arm FLASH for loading.
executing .\cmd\TBDML_vppon.cmd

!// Before programming the flash, the commands written below will be executed
done .\cmd\TBDML_vppon.cmd

Vppon command file correctly executed.
executing .\cmd\TBDML_vppoff.cmd

!// After programming the flash, the commands written below will be executed
done .\cmd\TBDML_vppoff.cmd

Vppoff command file correctly executed.
FP: FLASH disarmed.
executing .\cmd\TBDML_reset.cmd

!// After reset the commands written below will be executed
done .\cmd\TBDML_reset.cmd

Reset command file correctly executed.
executing .\cmd\TBDML_postload.cmd

!// After load the commands written below will be executed
RESET
done .\cmd\TBDML_postload.cmd

Postload command file correctly executed.
Error: Loading failed!

in>

已經困擾我好久了，我嘗試過解鎖，能解鎖；但每次解完，就顯示"unable to connect to target CPU"，求大神指點！！！！！！！！！

歡迎光臨電子工程網 (http://www.qingdxww.cn/)