国产毛片a精品毛-国产毛片黄片-国产毛片久久国产-国产毛片久久精品-青娱乐极品在线-青娱乐精品

ADI ADP1853輸出20A DC-DC轉換解決方案

發布時間:2012-7-3 12:21    發布者:1770309616
關鍵詞: ADI , ADP1853 , DC-DC
ADI 公司的ADP1853是寬輸入電壓DC/DC同步降壓控制器,輸入電壓從3.3V到12V(高達20V),電壓跟蹤輸入,輸出電壓0.6V到90%VIN,通常工作在電流模式以得到更快的響應速度.最大輸出電流大于25A,輸出電壓對溫度的精度±1%,可編頻率200 kHz到1.5 MHz,主要用于中間總線和POL系統,通信基站和網絡,工業和儀表,醫療和保健設備.本文介紹了ADP1853主要特性,方框圖,典型應用電路圖,15A電流模式和25A電壓模式應用電路圖,以及ADP1853評估板主要特性,電路圖,材料清單和PCB元件布局圖.

The ADP1853 is a wide range input, dc-to-dc, synchronous buck controller capable of running from commonly used 3.3 V to 12 V (up to 20 V) voltage inputs. The device nominally operates in current mode with valley current sensing providing the fastest step response for digital loads. It can also be configured as a voltage mode controller with low noise and crosstalk for sensitive loads.

The ADP1853 can be used as a master synchronization clock for the power system and for convenient synchronization between controllers. The CLKOUT signal can synchronize other devices in the ADP185x family such that slave devices are phase-shifted from the master to reduce the input ripple current, improve EMI, and reduce the size of the input bulk capacitance. The ADP1853 can also be configured as a slave device for current sharing. Additionally, the ADP1853 includes accurate tracking, precision enable, and power good functions for sequencing. The ADP1853 provides a high speed, high peak current gate driving capability to enable energy efficient power conversion. The device can be configured to operate in power saving mode by skipping pulses, reducing switching losses and improving efficiency at light load and standby conditions.

The accurate current limit allows design within a narrower range of tolerances and can reduce overall converter size and cost. The ADP1853 can regulate down to 0.6 V output using a high accuracy reference with ±1% tolerance over the temperature range from −0℃ to 125℃.

With a wide range input voltage, the ADP1853 is designed to provide the designer with maximum flexibility for use in a variety of system configurations; loop compensation, soft start, frequency setting, power saving mode, current limit, and current sense gain can all be programmed using external components. In addition, the external RAMP resistor allows choosing optimal slope and VIN feedforward in both current and voltage mode for excellent line rejection. The linear regulator and the boot strap diode for the high-side driver are internal.

Protection features include undervoltage lock out, overvoltage, overcurrent/short circuit, and overtemperature.

ADP1853主要特性:

Input voltage range: 2.75 V to 20 V

Output voltage range: 0.6 V to 90% VIN

Maximum output current of more than 25 A

Current mode architecture with current sense input

Configurable to voltage mode

±1% output voltage accuracy over temperature

Voltage tracking input

Programmable frequency: 200 kHz to 1.5 MHz

Synchronization input

Internal clock output

Power saving mode at light load

Precision enable input

Power good with internal pull-up resistor

Adjustable soft start

Programmable current sense gain

Integrated bootstrap diode

Starts into a precharged load

Externally adjustable slope compensation

Suitable for any output capacitor

Overvoltage and overcurrent-limit protection

Thermal overload protection

Input undervoltage lockout (UVLO)

Available in 20-lead, 4 mm × 4 mm LFCSP

Supported by ADIsimPower™design tool

ADP1853應用:

Intermediate bus and POL systems requiring sequencing and tracking, including

Telecom base station and networking

Industrial and Instrumentation

Medical and healthcare

圖1.ADP1853方框圖

圖2.ADP1853典型應用電路圖

圖3.ADP1853兩相應用電路圖

圖4.ADP1853 15A電流模式應用電路圖

圖5.ADP1853 25A電壓模式應用電路圖

ADP1853降壓DC/DC控制器評估板

This document describes the design, operation, and test results of the ADP1853-EVALZ. The input voltage range for this evaluation board is 9 V to 15 V, and the regulated output voltage VOUT is set to 3.3 V with the maximum output current up to 20 A. The switching frequency (fSW) of 300 kHz is set to achieve high efficiency.

ADP1853評估板主要特性:

Input voltage range: 9 V to 15 V

Output voltage: 3.3 V

Output current: up to 20 A

Switching frequency: 300 kHz

Operates in PWM or PSM

Designed for evaluation of the ADP1853 functionality

Flexible and easy to re-configure and modify

圖6.ADP1853評估板外形圖

圖7.ADP1853評估板電路圖
ADP1853評估板材料清單:



圖8.ADP1853評估板元件布局圖(頂層)
詳情請見:
ADP1853.pdf (838.55 KB)

UG-431.pdf (625.51 KB)

來源:網絡
本文地址:http://www.qingdxww.cn/thread-93494-1-1.html     【打印本頁】

本站部分文章為轉載或網友發布,目的在于傳遞和分享信息,并不代表本網贊同其觀點和對其真實性負責;文章版權歸原作者及原出處所有,如涉及作品內容、版權和其它問題,我們將根據著作權人的要求,第一時間更正或刪除。
您需要登錄后才可以發表評論 登錄 | 立即注冊

廠商推薦

  • Microchip視頻專區
  • Dev Tool Bits——使用MPLAB® Discover瀏覽資源
  • Dev Tool Bits——使用條件軟件斷點宏來節省時間和空間
  • Dev Tool Bits——使用DVRT協議查看項目中的數據
  • Dev Tool Bits——使用MPLAB® Data Visualizer進行功率監視
  • 貿澤電子(Mouser)專區

相關在線工具

相關視頻

關于我們  -  服務條款  -  使用指南  -  站點地圖  -  友情鏈接  -  聯系我們
電子工程網 © 版權所有   京ICP備16069177號 | 京公網安備11010502021702
快速回復 返回頂部 返回列表
主站蜘蛛池模板: 福利视频一区二区 | 九九在线视频 | 欧美又硬又粗又长又大 | 亚洲人性生活视频 | 轮流操| 成人免费在线视频网 | 幻女与人xx00毛片免费 | 国产网站免费在线观看 | 黄免费视频 | 四虎影视永久在线观看 | 午夜视频免费 | 日本一区二区三区免费看 | 99热成人精品国产免男男 | 日韩不卡一二三区 | 国产精品亚洲午夜一区二区三区 | 亚洲欧美一区二区三区国产精品 | 高清精品一区二区三区一区 | 国外成人免费视频 | 一区二区三区四区视频在线 | 性情视频在线高清免费 | 欧美www在线观看 | 99热在线观看精品 | 四虎影院www| 内地精品露脸自拍视频香蕉 | 日韩在线免费看 | 欧美成人黄色片 | 91精品国产色综合久久不卡蜜 | 亚洲欧美一区二区三区久久 | 免费高清不卡毛片在线看 | 91精品国产麻豆91久久久久久 | 91小视频在线观看免费版高清 | 香蕉国产人午夜视频在线观看 | 久久系列 | 国产精品国产三级国产专区5o | 国产亚洲人成网站观看 | 日日夜夜天天 | 1024在线观看国产天堂 | 日韩综合在线视频 | 久久99精品久久久 | 亚洲毛片在线播放 | 久久久久国产亚洲日本 |